TenTec
[Top] [All Lists]

Re: [TenTec] Triton IV 544 Digital

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Triton IV 544 Digital
From: "Paul Christensen" <w9ac@arrl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 26 Feb 2021 11:20:29 -0500
List-post: <mailto:tentec@contesting.com>
Mike,

Interesting.  If the 544 schematic is correct, the Display Board has no common 
+Vcc.  +Vcc is supplied individually to each 7-segment LED module via Q14-Q19 
(PNP) on the Logic Board.  +Vcc on the Logic board is RF bypassed  with a 
0.047uF cap at C6.   +Vcc on the Logic Board is also connected to IC-1 with 
ample decoupling, consisting of a 22 ohm resistor and a 0.1 uF cap at C7.  The 
22 ohm resistor is mainly there to regulate current into a Zener diode that 
feeds +Vcc to IC-1 but it also functions to decouple.  

To me it looks like Ten Tec adequately decoupled one part of the Logic Board, 
but not the other going into the display board.   The only problem with 
duplicating R/C de-coupling on the +Vcc bus feeding Q14-Q19 is that any series 
resistance will make the display slightly dimmer -- and the green LED segments 
are already way too dim due to green-wavelength filtering through the smoked 
Plexiglass lens.  So, that leaves adding an additional RF bypass across C6 
(0.047 uF). Possibly something like a 4.7 uF 'lytic cap in parallel with a 0.22 
uF film bypass will do the trick.  

Paul, W9AC

-----Original Message-----
From: TenTec <tentec-bounces+w9ac=arrl.net@contesting.com> On Behalf Of Mike 
Bryce
Sent: Friday, February 26, 2021 10:47 AM
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Triton IV 544 Digital

When you first hear it, you’d bet money that the calibrator is running. 
However, there isn’t one in the digital Triton 4. 
Decoupling the power supply will reduce the signal level to a point you won’t 
notice it with an antenna connected.

One of my Drake TR5s did the same thing. Its counter/display put a S-7 signal 
right on the MIDCARS freq of 7.258. Recaping the display pcb eliminated 94% of 
the problem


Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o 

> On Feb 26, 2021, at 8:10 AM, Paul Christensen <w9ac@arrl.net> wrote:
> 
> Thanks, Mike.  I'll look into it.
> 
> Paul, W9AC
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>