TenTec
[Top] [All Lists]

Re: [TenTec] Triton IV 544 Digital

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Triton IV 544 Digital
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 25 Feb 2021 22:41:36 -0500
List-post: <mailto:tentec@contesting.com>
Unplug the the frequency display and see if the signal goes away. The signal 
 is coming from that unit. Verify it first and the decouple the vcc going into 
the display unit 

Mike. Wb8vge

Sent from my iPad

Knowledge is knowing a tomato is a fruit; Wisdom is not putting it in a fruit 
salad.
 

> On Feb 25, 2021, at 10:11 PM, Paul Christensen <w9ac@arrl.net> wrote:
> 
> I'm nearly finished with the restoration of a Triton IV (544 digital).  I 
> hear a pulsing frequency marker at 14.0 MHz but my 544 manual makes no 
> mention of it.  It's definitely not a 25 kHz or 100 kHz crystal calibrator.  
> It's continuously there with no means to turn it on/off.  I thought that 
> perhaps it's a third-party add-on unit or perhaps a homebrew mod, but I don't 
> see anything that would indicate either.  
> 
> Comments?
> 
> Paul, W9AC   
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>