1-2 of 2 messages
|
Page 1 of 1
|
RMC -1000 Power Relay Sparking
|
Reply
|
by k5hsv on June 20, 2006
|
Mail this to a friend!
|
I purchased a US Tower, HDX-555 with RMC-1000 used. After setting everything up I put the power to the MDP-750 motor drive and got sparks at the contacts of the Power Relay. I called US Tower and was told what part to order from Granger (power relay). Did that, replaced it and still getting sparks. I have to hold pressure on the new relay, just as I did on the old one inorder to get the tower to raise and lower... which it does flawlessly with the pressure on the contact bar. Any suggestions??? I need help on this one considering I'm getting no solutions with USTower.
TNX/ 73s,
Paul - K5HSV
|
|
RE: RMC -1000 Power Relay Sparking
|
Reply
|
by k5hsv on July 19, 2006
|
Mail this to a friend!
|
Thanks to everyone here at, the problem was fixed. Nothing more than low voltage caused by a long extension cord. I ran a flex conduit from the breaker box to a recessed out side plug... problem solved. Thanks for everyones help!
73's
Paul - K5HSV
|
|
|
Email Subscription
You are not subscribed to this topic.
Subscribe!
My Subscriptions
Subscriptions Help
Check our help page for help using
Forums, or send questions, comments, or suggestions to the
Forums Manager.
|