TenTec
[Top] [All Lists]

Re: [TenTec] Mic

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Mic
From: Rick Cochran via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 10 May 2021 10:44:05 -0400
List-post: <mailto:tentec@contesting.com>
Thanks, Vic.

I’ll try that.

Rick
WO8L 

Sent from my iPhone

> On May 10, 2021, at 5:59 AM, Vic Klein via TenTec <tentec@contesting.com> 
> wrote:
> 
> The 705 mic is pretty hot, compared to others like the 707, and I needed to
> turn the hardware mic gain control down from 100% to 12% to use it. After
> that, the settings for mic gain, SSB band width, and equalizer were the same
> as I use with the 707 as I recall. Without adjusting that mic gain the 705
> vastly overloads that first amplifier which is before the software mic gain
> that you control from the front panel. That hardware gain is the pot under
> the front panel on the right side and turns CCW for maximum.
> 
> 73, =Vic=
> WA4THR
> ---------------------------------------------------------------------------
> To:    tentec@contesting.com
> Subject:    [TenTec] Mic
> From:    Rick Cochran via TenTec <tentec@contesting.com>
> Reply-to:    Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Date:    Sun, 9 May 2021 19:36:50 -0400
> List-post:    <mailto:tentec@contesting.com>
> 
> I've found an old Ten Tec 705 mic which I'm trying to use with an Omni VII.
> 
> However, I got a report of "fuzzy" audio but it was understandable.
> 
> What are good settings for mic gain, ssb tx band with,  tx equalizer and
> speech 
> processor?
> 
> Thanks,
> 
> Rick
> WO8L
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>