TenTec
[Top] [All Lists]

Re: [TenTec] OMNI VI and fast switching amp hook up ?

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] OMNI VI and fast switching amp hook up ?
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 30 Nov 2005 21:26:54 -0500
List-post: <mailto:tentec@contesting.com>
The timing will be wrong if you do this.  The omni VI will start
transmitting before your amp antenna relay has transfered.  What you need is
for TXOUT to energize your amp antenna relay and then use a contact on the
amp antenna relay to return ground back to TXEN.  This guarantees the amp
antenna relay transfers before transmitting begins.  This is exactly what
tentec QSK amps do.

Carl Moreschi N4PY
Franklinton, NC
----- Original Message ----- 
From: <dbp@tds.net>
To: <tentec@contesting.com>
Sent: Wednesday, November 30, 2005 8:59 PM
Subject: [TenTec] OMNI VI and fast switching amp hook up ?


> Hi-
>  I have an OMNI VI and a TL-922a amp which I just finished wiring with
vacuum relays for QSK fast switching. Works great but, the OMNI relay used
to key non Ten Tec amps is annoying on CW. (Not real annoying but....)
>  Of course when not using the amp, which is 99.9% of the time I can switch
the relay off and have quiet CW.
>  Is there any reason why I can't tap into the TX EN and TX OUT jumper with
a "Y" connection and run the quiet transistor switching to ground since TX
OUT does go to ground when its active and then leave the relay OFF?
>
> 73 de Dave in NH  K1OPQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>