TenTec
[Top] [All Lists]

[TenTec] Re: [Orion] Orion Mike plug

To: orion@contesting.com, tentec@contesting.com
Subject: [TenTec] Re: [Orion] Orion Mike plug
From: WB3LGC@aol.com
Reply-to: tentec@contesting.com
Date: Wed, 21 Jul 2004 17:54:21 EDT
List-post: <mailto:tentec@contesting.com>
I am also a new buyer (purchased back at June 9th - don't expect it to be 
shipped until first or second week in August.)  

I purchased a Goldline, Heil cable, and a XLR connector as the mike for the 
Orion.  The four pin XLR also has a "case" connection for the shield and pins 
(2) for the mike and pins for the PTT (2).  If you open up the mike, the case 
provides the shield for the microphone wires.

Pin 4, on the goldline is PTT and on the Orion +9VDC -- not sure why you 
would want to ground it? (Heil must also mean for you to remove the +9VDC 
connection from the Orion. -- that is a nice idea...)

I had seen a few emails back last month about Ten-Tec changing the way the 
connector was grounded for the Orion as it comes from the Factory.  I can't 
verify the information, at this time.  As I am still waiting, I'll know in a 
few 
weeks.  the trick seems to get the cable shield and the 4-pin Orion connector 
shell grounded.  BTW, Heil Wire has two (2) mike wires with shield plus two (2) 
PTT wires (unshielded) -- nice heavy cable.

73, Steve


In a message dated 7/20/2004 1:05:35 PM Eastern Standard Time, 
ablee@bellsouth.net writes:
Am a  prospective buyer....but, before taking the plunge....

Had an interesting land line with Bob Heil re using his mikes and
the Orion.  Apparently, Ten-Tec's insistence on using the old 4-prong
mike connector and also to relying on the SHELL for the ground has
caused problems in using Heil's mikes.
He recommends going into the Orion and moving the ground from the
shell back to pin 4.
Any comments?

73's
Joe, KX4JR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>