RFI
[Top] [All Lists]

Re: [RFI] USB Cable Shield Resistance was: Re: [N1MM+] open question abo

To: "Jeff (W4DD)" <w4dd09@gmail.com>, N1MMLoggerPlus@groups.io, 'RFI List' <rfi@contesting.com>
Subject: Re: [RFI] USB Cable Shield Resistance was: Re: [N1MM+] open question about RFI & USB
From: Pete Smith N4ZR <pete.n4zr@gmail.com>
Date: Tue, 16 Jan 2024 11:40:43 -0500
List-post: <mailto:rfi@contesting.com>
Oh Joy - another thing to check.  I'm using a plain Ethernet Cat 5 patch cable from my amp to my computer.  Judging by how floppy it is, I suspect no shielding at all - but a question - if there were a shield, which pin on the Ethernet connector would it be?

73, Pete N4ZR

On 1/16/2024 10:22 AM, Jeff (W4DD) wrote:
Pete, just another data point based on my experience with shielded Ethernet 
cables.  Excerpt from one of my PPT's follows.  I found the shield connections 
to be intermittent.



Do Not Use Shielded Ethernet Cables from the Common Internet Sites
The shield is not soldered to the metal RJ-45 shell.  I measured 2-20 ohms on a 
group of 5 jumper cables shell to shell.  Mouser Electronics has Amphenol 
Ethernet cables ($7) with the drain wire soldered to the metal RJ-45 shell at 
both ends.  Resistance was less than 1 ohm for each of 5 cables measured (view 
the spec sheet at Mouser.com).

Jeff, W4DD

-----Original Message-----
From: RFI<rfi-bounces+w4dd09=gmail.com@contesting.com>  On Behalf Of Pete Smith 
N4ZR
Sent: Tuesday, January 16, 2024 9:32 AM
To:N1MMLoggerPlus@groups.io; RFI List<rfi@contesting.com>
Subject: [RFI] USB Cable Shield Resistance was: Re: [N1MM+] open question about RFI 
& USB

Interestingly, I just tested the shielding on a USB A to USB C cable I have, 
which looked like it should be fine, with a transparent jacket over woven 
shielding and a big ferrite bead - about 1 meter long, and measured 2.7 ohms - 
not good.  What should be consider to be the upper permissible shield 
resistance?

Moving this issue to the RFI reflector now...

73, Pete N4ZR

On 1/16/2024 5:01 AM, Janez Majdic via groups.io wrote:
Maybe also good to read:
https://www.yoctopuce.com/EN/article/usb-cables-shielding-matters-as-w
ell

Regards, Janez - S51J
_._,_._,_
----------------------------------------------------------------------
--
Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#82277)
<https://groups.io/g/N1MMLoggerPlus/message/82277>  | Reply To Group
<mailto:N1MMLoggerPlus@groups.io?subject=Re:%20Re%3A%20%5BN1MM%2B%5D%2 0open%20question%20about%20RFI%20%26%20USB>
| Reply To Sender
<mailto:s51janez@yahoo.com?subject=Private:%20Re:%20Re%3A%20%5BN1MM%2B %5D%20open%20question%20about%20RFI%20%26%20USB>
| Mute This Topic<https://groups.io/mt/103743186/515779>  | New Topic
<https://groups.io/g/N1MMLoggerPlus/post>
Your Subscription<https://groups.io/g/N1MMLoggerPlus/editsub/515779>
| Contact Group Owner<mailto:N1MMLoggerPlus+owner@groups.io>  |
Unsubscribe
<https://groups.io/g/N1MMLoggerPlus/leave/1691550/515779/1128496821/xy zzy>
[pete.n4zr@gmail.com]

_._,_._,_
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
<Prev in Thread] Current Thread [Next in Thread>