Pete,
You must always “Frank” all PL-259 connectors using a small wrench to complete
the physical and electrical connection.
“Franking” PL-259 connectors is a W3LPL-ism mentioned at each and every
Contest University presentation.
Jack, W3KX
Sent from my iPhone
> On Sep 25, 2023, at 1:23 AM, NA6MB Mike <na6mb.mike@gmail.com> wrote:
>
> Most likely the small movement you put in the connector when tightening it
> moved some oxide out of the way and removed a higher impedance spot
>
> NA6MB
>
>
>> On Sun, Sep 24, 2023, 3:16 PM Pete Smith N4ZR <pete.n4zr@gmail.com> wrote:
>>
>> This morning I got up and went on the air in the CQWW RTTY Contest.
>> Everything had been fine yesterday, but as soon as I made my first
>> transmission, both of my monitors shut down. Eventually, I found that
>> the cause was RFI - anything over about 40 watts and blooey (the
>> computer was fine). Without a lot of excruciating detail, I think the
>> cause was a hand-tight PL-259 somewhere in my feedline out to my antenna
>> switch. Initially it looked fjne, and then it started showing me high
>> SWRs on all bands. I snugged them all down and it went away.
>>
>> This is a first to me in some 40 years of playing radio and computers.
>>
>> --
>> 73, Pete N4ZR
>> _______________________________________________
>> RFI mailing list
>> RFI@contesting.com
>> http://lists.contesting.com/mailman/listinfo/rfi
>>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|