1-3 of 3 messages
|
Page 1 of 1
|
HAM-IV Problem
|
Reply
|
by OZ2Q on May 25, 2001
|
Mail this to a friend!
|
Have a little problem with my rotator. The meter goes full scale when turned on, and do not show the direction.(not i calibration mode!) When turned of, meter SLOWLY goes back to left position. Rotator unbreaks and turns OK.
Is problem pot in rotator or in controlbox?
Best 73 de OZ2Q - Frits in Copenhagen
|
|
RE: HAM-IV Problem
|
Reply
|
by k1zjh on May 26, 2001
|
Mail this to a friend!
|
Does the manual show the resistance checks for
metering the cable towards the controller?
Earlier models did. This should allow you to meter
the pot resistance--which would indicate whether
the control cable or pot is open rather easily from
the operating position.
Peter
|
|
RE: HAM-IV Problem
|
Reply
|
by W4ZT on December 16, 2002
|
Mail this to a friend!
|
Sounds like your pot is burned. Even momentary shorting of control wires can smoke the pot and will give a full scale meter indication. Tony
|
|
|
Email Subscription
You are not subscribed to this topic.
Subscribe!
My Subscriptions
Subscriptions Help
Check our help page for help using
Forums, or send questions, comments, or suggestions to the
Forums Manager.
|