1-3 of 3 messages
|
Page 1 of 1
|
Computer Interface for Kenwood 440S
|
Reply
|
by NN7L on August 26, 2000
|
Mail this to a friend!
|
I have had difficulty trying to locate the accessories required to connect my pc to my Kenwood 440S. Are there any alternatives to using the IF232C and IC-10?
Thank you,
Jason
NN7L
|
|
RE: Computer Interface for Kenwood 440S
|
Reply
|
by N2MG on September 1, 2000
|
Mail this to a friend!
|
Hi Jason,
I don't usually answer posts that I have no answer for <grin> but since this had not been responded to after 5-6 days...
I know of no 3rd-party source for the computer interface for a 440. FWIW, the TS-930/940 are far more popular contest rigs and each have recently had an aftermarket board designed by PIEXX.
http://www.piexx.com/
You might email them and ask if there are any plans for a 440 unit.
73
Mike
N2MG
|
|
RE: Computer Interface for Kenwood 440S
|
Reply
|
by n5zq on September 19, 2000
|
Mail this to a friend!
|
There are a couple of companies that make the chipset that goes inside the radio and the interface that connects the radio to your computer. Here is just 1 of those places. http://www.qth.com/prolog/riginterface.htm
N5ZQ
|
|
|
Email Subscription
You are not subscribed to this topic.
Subscribe!
My Subscriptions
Subscriptions Help
Check our help page for help using
Forums, or send questions, comments, or suggestions to the
Forums Manager.
|