eHam Logo

 Home Home
 Articles & Stories
 Contesting Wiki
 My Profile

 This Week's Contests
 Classified Ads
 Contest Links
 Product Reviews

Contest Lists

Other Lists

 Mailing List FAQs

Site Information
 About This Site Team

Contesting Online Forums : Tips : Rtty Pinout Forums Help

1-2 of 2 messages

  Page 1 of 1  

Rtty Pinout Reply
by K2AT on April 8, 2001 Mail this to a friend!
Need RTTY pinout for cabling between the Yaesu FT1000D and the Kam. The Yaesu manual is wrong. Any help would be much appreciated as I near going nuts. Help!!
RE: Rtty Pinout Reply
by ka2d on April 12, 2001 Mail this to a friend!
Hello Mel

Here is what I have.

KAM <------------->FT1000D (RTTY jack)
2 GND/shield<-------->4 GND
3 PTT<----------->3 PTT
4 CW
5 FSK<---------->1 RTTY
6 RCV audio <---------->I used the recv audio from the ext speaker

Set the command of the KAM to "FSkinv to ON".
The default is OFF. This is unique to the FT1000.
If this is not set correctly, your TX will be inverted.

I sure you did this, but read and verify the FT1000 dip switch settings for FSK. Page 16 of operating manual.

Hopes this helps.

CU - Tom KA2D

  Page 1 of 1  

Next Topic:   YAESU- G 10000 ROTOR
Previous Topic:   Using VOX or Footswitch for SSB Contests?
Email Subscription
You are not subscribed to this topic.

My Subscriptions
Subscriptions Help

Search Tips:

Check our help page for help using Forums, or send questions, comments, or suggestions to the Forums Manager.