Towertalk
[Top] [All Lists]

Re: [TowerTalk] 3M™ External PIM Absorber 1000 | 3M United States

To: ersmar@verizon.net, towertalk@contesting.com
Subject: Re: [TowerTalk] 3M™ External PIM Absorber 1000 | 3M United States
From: "Jim Lux" <jim@luxfamily.com>
Date: Sat, 18 Nov 2023 16:40:44 -0500
List-post: <mailto:towertalk@contesting.com>
        


I’ve used similar products at lower frequencies (<30 MHz) to good avail for 
knocking down RFI carried on power and data cables. It’s basically a 
ferrite/powdered metal in a elastomeric binder, or you can get it as an 
adhesive tape. So the mix of the ferrite is important - something like a 31 mix 
would be better than a mix tailored for higher frequencies.
I think the stuff I’ve used most recently came from Laird. 
It’s also used inside enclosures to suppress cavity modes, and on the outside 
of horns to suppress creeping waves on the outside of the horn.

There are “evaluation kits” available for around $50-100 that have a whole 
selection of different materials, typically in 6x6” sheets or strips of tape or 
whatever.
 


On Sat, 18 Nov 2023 20:52:17 +0000 (UTC), Gene Smar via TowerTalk 
<towertalk@contesting.com> wrote:

This link worked for me. Can't find application info for freqs below 700 MHz.
https://www.3m.com/3M/en_US/p/d/b5005318008/


73 de Gene Smar AD3F

Sent from my Radio Shack TRS-80 model 100 laptop
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
 



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>