Towertalk
[Top] [All Lists]

Re: [TowerTalk] EHS cable and torque bars

To: towertalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] EHS cable and torque bars
From: Steve Maki <lists@oakcom.org>
Date: Fri, 9 Jun 2023 21:36:06 -0400
List-post: <mailto:towertalk@contesting.com>
Destroying the bracket? What are you talking about? 1/4" EHS is SPECIFIED on tall R45's.

-Steve K8LX

On 2023-06-09 9:27 PM, Ron WV4P wrote:
When the Catenary weight of 1/4" EHS changes the angle of the torque bar to destroying the bracket VS resisting twist it all makes sense... Adding larger shackles compounds the issue.

Likely not an issue with your short tower but worth a call to Rohn.

Ron, WV4P

On Fri, Jun 9, 2023 at 8:21 PM Steve Maki <lists@oakcom.org> wrote:

    That's idiotic, or at least short sighted.

    Use the biggest pin shackle that will fit in the torque arm, and 1/4"
    big grips (preforms) with thimble in the shackle. This makes it
    easy to
    remove a guy wire temporarily whenever needed.

    As has been pointed out often, the torque arms don't do much for
    rotational resistance, but if you have them, use them. It makes a
    nice
    install.

    -Steve K8LX

    On 2023-06-09 8:34 PM, Mike H wrote:
    > I acquired some used Rohn 45G in very good shape and will be
    going up
    > 50 ft. Antenna will be stacked 2 x 9-el for 2m. I'm following
    the Rohn
    > engineering guidance very closely: base is a new R-SB45G buried
    in the
    > prescribed concrete block along with GAR30 guy anchors, also in
    > concrete. I have the older style guy bracket for 45G that has (very
    > expensive!) TB45D torque bars
    >
    
<https://www.3starinc.com/rohn_45g_torque_bars_for_use_with_guy_bracket_r-tb45d.html>

    > along with several hundred feet of brand-new 1/4 in EHS for the
    guys.
    > According to the Rohn instructions, however, I can't use EHS cable
    > that's greater than 3/16 in:
    >
    > https://www.3starinc.com/manuals/ROHN_Torque_Bar.pdf
    >
    > This means I'd have to buy either smaller EHS cable or their
    newer guy
    > bracket that doesn't use torque bars. I'll do this if I have to,
    but
    > I'd sure like to understand why 1/4 in EHS is a deal-breaker for
    the
    > torque bars. QTH is north Florida so I want to make the setup as
    > storm-proof as practical. Any insight appreciated.
    >
    > Mike WB2FKO
    > _______________________________________________
    >
    >
    >
    > _______________________________________________
    > TowerTalk mailing list
    > TowerTalk@contesting.com
    > http://lists.contesting.com/mailman/listinfo/towertalk
    _______________________________________________



    _______________________________________________
    TowerTalk mailing list
    TowerTalk@contesting.com
    http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>