Re: [TowerTalk] Rohn TB-3 thrust bearing

[CEPitts <cpitts@ec.rr.com>]

Al is correct! Thank you Al for the correction...Doufus me was reading a 
scale that had it broken down into 1/32" so Al should have it right! 
Carry on everybody and good luck Mark! Charles "Ed" K5OF

On 5/26/2021 11:02 AM, Al Kozakiewicz wrote:
> 1.875 in (1 7/8") is 47.625 mm.
>
> Al
> AB2ZY
>
> -----Original Message-----
> From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of CEPitts
> Sent: Wednesday, May 26, 2021 10:09 AM
> To: towertalk@contesting.com; mpridesti@yahoo.com
> Subject: Re: [TowerTalk] Rohn TB-3 thrust bearing
>
> Ugh! Correction, reading the mm wrong, it looks like it should be 59mm!
> sorry about that! Charles "Ed' K5OF
>
>
> On 5/26/2021 9:58 AM, CEPitts wrote:
> > Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it
> > is off it only by 1mm according to my handy little caliper. If others
> > respond hopefully they confirm what I have provided. Charle4s "Ed"
> > K5OF in NC
> >
> > Hello group!
> >
> > Could someone here give me the precise inside diameter of this
> > bearing? Quick checks in the Rohn catalog (over 230 pages) I was
> > unable to find it.
> >
> > Thanks!
> >
> > Regards,
> >
> > Mark, K1RX
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk