Towertalk
[Top] [All Lists]

Re: [TowerTalk] Half Wave?

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Half Wave?
From: "Joe Subich, W4TV" <lists@subich.com>
Date: Thu, 17 Jan 2019 17:43:05 -0500
List-post: <mailto:towertalk@contesting.com>
On 2019-01-17 5:24 PM, Bob Shohet, KQ2M wrote:
>
Simply put, antennas at a given height have MULTIPLE lobes at different wave angles of varying gain over flat ground over average
soil.
Not quite accurate ... dig out an ARRL Antenna Book or modeling program
and you will find that a horizontal antenna does not develop a second
lobe until it is more than 1/2 wave above flat ground, a third lobe
until it is more than 1 wave above flat ground, a fourth lobe until it
is more than 1.5 wave above flat ground, etc.

Since the first lobe is rather broad and the original question was about
the difference between 63 an 67 feet for a 40 meter yagi, the answer is
"not enough to worry about."  The difference between 63 and 67 feet will
be more than swamped by any irregularities in the terrain.  Now, if the
question had been about the difference between 40 and 65 feet, the
answer would have been significantly different.

73,

   ... Joe, W4TV


On 2019-01-17 5:24 PM, Bob Shohet, KQ2M wrote:
Simply put, antennas at a given height have MULTIPLE lobes at different wave angles of 
varying gain over flat ground over average soil.  If you have anything other than flat 
ground and especially if you have complex terrain or are on the side of a hill or 
adjacent to water, your antenna at 1/4 or 3/8 wave height above ground might have 
useful high angle lobes and some unexpected low angle lobes despite the low height.  
This is why it is important to model your antenna over actual terrain – and the 
ground conductivity with fertile ground vs. sandy soil or ledge also makes a 
difference and can be quite helpful.

I live in Western CT and on 160  I use a wire Inverted L with a top height of 85’ with the rest of the wire horizontal and 3 elevated 1/4 wave radials no greater 
than 10’ above ground.  It is a proverbial “cloud warmer” and yet I have worked 200+ countries and 33 zones with it along with a handful of 
JA’s on 160. And I haven’t tried very hard.  And the antenna is on ledge and deep forest “soil” on the top of a hill with awful ground 
conductivity.  The hill helps but it is primarily a high angle antenna – no matter – it works fairly well most of the time.   It would work better if it was 
all vertical but that is not possible at my qth.  If I listened to the “doom and gloom” of some opinions about height above ground I wouldn’t have 
bothered to put it up or even tune the band.

Bottom line:

MODEL several proposed antennas over your specific terrain at your qth.  You 
may discover advantages at a given height that are counter-intuitive, and then 
put it up and get on the air.  Often your antenna will be far more useful than 
you could imagine despite what others think.

BTW, most antennas are louder over some path at different times depending on the height (or lack of 
it).  My 3 L wire beam @ 50’ on 40 is VERY loud to EU for about 2 hours early in the opening; 
as loud as a yagi would be at the same time at a high height. The difference is that after those two 
hours, the Yagi would be 10 db – 2 s-units louder from the combination of antenna gain PLUS 
being at a higher and more optimum height for the given arrival wave angles from EU.  The wire beam 
has its usefulness even though a quality Yagi at a high height would be better.  What would be best 
is to have both – each for its advantages at different times.

Actual results trump theory.  If it works then use it.  If it works well then 
enjoy it regardless of what anyone else thinks about it!

63’ vs. 67’ on 40 is not even worth considering if it looks close enough after 
modeling it over your terrain.  Go with whatever is easiest for you.

73

Bob  KQ2M


From: Peter Voelpel
Sent: Thursday, January 17, 2019 3:37 PM
To: 'Tower Talk'
Subject: Re: [TowerTalk] Half Wave?

A 1/4 wave length height IS exactly a cloud warmer.
At least 3/8 wave length height is necessary for a lower take off angle.

73
Peter

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Keith
Dutson
Sent: Donnerstag, 17. Januar 2019 21:27
To: Tower Talk
Subject: Re: [TowerTalk] Half Wave?

My experience is that 1/4 wavelength is okay to avoid a cloud warmer.
However, higher is always better for DX, aka lower take-off angle.

73, Keith NM5G

-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Warren Wolff
via TowerTalk
Sent: Thursday, January 17, 2019 11:47 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Half Wave?

Greetings:   My understanding is that a yagi should be at least 1/2wave
above ground to avoid warming the clouds.   So, considering that thought,
how much does an antennasuffer if such antenna is 63 feet up instead of 67
feetfor 40 meters over VERY rocky "soil"?   Thanks, Warren; W7WY
_______________________________________________




_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>