Towertalk
[Top] [All Lists]

[TowerTalk] Voltage Breakdown For Enameled Wire

To: <towertalk@contesting.com>
Subject: [TowerTalk] Voltage Breakdown For Enameled Wire
From: "Jim Thomson" <jim.thom@telus.net>
Date: Tue, 30 Jan 2018 08:37:20 -0800
List-post: <mailto:towertalk@contesting.com>
Date: Sun, 28 Jan 2018 18:02:55 -0800
From: Jim Brown <jim@audiosystemsgroup.com>
To: towertalk reflector <towertalk@contesting.com>
Subject: [TowerTalk] Voltage Breakdown For Enameled Wire

<I'm once again considering winding high power chokes with enameled wire. 
Zo of a closely #12 pair is about 53 ohms, which makes it desirable IF 
breakdown voltage is sufficient. I would appreciate for sources of #10 
or #12 enameled wire with published breakdown specs.

I've found that THHN (about 93 ohms Zo) works fine for simple antennas 
like dipoles, but some multiband antennas with complex matching/coupling 
systems don't like that much mismatch. We had this problem with the 
Force 12 C3SS, the choke is enameled #12 of unknown pedigree. No 
breakdown issues with a 600W power amp and the antenna is a good match 
to it, but the engineer in me wants to be conservative for legal limit 
to an 80/75 dipole that I use from 3.5-3.9 MHz.

Yes, I know I could put the conductors in Teflon tubing, but that 
increases Zo. I've measured #12 pairs with various Teflon insulation and 
get values around 101 ohms at HF.

Suggestions?

73, Jim K9YC

##  I bought a bunch of 10 gauge and also 8 gauge  from SSON, on sale,
years ago.  It used polyimide.  Was rated for  15 kv, at least in the larger 
gauges,
like  14-12-10-8.    V rating was reduced with the smaller gauges, since if  15 
kv
insulation used on real small stuff, like   18-28 gauge wire, then the 
insulation  would be super
thick compared to the actual  small gauge wire diameter itself...and  28 gauge 
wire would resemble
something like 20 gauge wire.   

##  In  Orrs very last handbook, the blue covered one, they had a chart at the 
back of the book, showing
3 different  diameters for the SAME  gauge magnet wire.   The difference  
between the 3 was the thickness
of the insulation used.    This can have a profound effect when winding plate 
chokes for tube amps, and explains
why 2 identical wound chokes  can have series resonances on  different freqs.   
The turns per inch was less
when the thicker insulation was used. 

##  The stuff I bought hi pot tested to > 15 kv.  And  >  30 kv between  
adjacent turns.   If you really want to go crazy,
you can slide it into teflon tubing, but as you stated, for your application, 
Zo increases too much.   For my application,
I was just using it for bifilar fil chokes..and the  15 kv rating was gross 
overkill anyway, but at the time, the price was right.

##  What ever you end up buying, easy enough to hi pot test it, which is typ 
done at  DC..or  60 hz  AC. 

Jim   VE7RF 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>