Towertalk
[Top] [All Lists]

[TowerTalk] thimble gap too narrow

To: <towertalk@contesting.com>
Subject: [TowerTalk] thimble gap too narrow
From: w7ni@teleport.com (Stan Griffiths)
Date: Mon, 9 Jun 1997 02:34:14 -0700 (PDT)
>Hi Folks,
>
>The thimbles I got from Texas Towers and Hill Radio come down to a narrow gap,
>too small for the thimble to slip over a turnbuckle or shackle. I need a 
>practical idea for increasing the gap from around 3/16" to 7/16". The 3/8" 
>thimbles are made of thick metal and are extremely stiff. 
>
>Regards,
>Pete
>KS4XG
>
>(Hill Radio came through with my special order of Rohn parts. I'm very
>satisfied with their prices and service.)

I found the easiest way to deal with that problem is to clamp one side of
the thimble in my bench vise and bend the other side away from it with a
pair of pliers.  This opens the jaws up "sideways" and you close them the
same way after the turnbuckle is installed.  You can then squeeze the
thimble jaws a little tighter by rotating the thimble 90 degrees in the vise
and closing the vise on them.  Sometimes a little of the galvanizing flakes
off in this operation but I have never regarded that as a significant problem.

Stan  w7ni@teleport.com


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>