TenTec
[Top] [All Lists]

Re: [TenTec] Ten Tec Orion II problem -- will not power on

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Ten Tec Orion II problem -- will not power on
From: BERNARD SKOCH via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 14 Feb 2022 14:36:39 -0600
List-post: <mailto:tentec@contesting.com>
I would try another power supply and check the A9 board (it may have failed 
after you rebuilt it).

I would also check the integrity of the power connector.


> On Feb 14, 2022, at 13:53, Marcus Florido <k4vbb@live.com> wrote:
> 
> In October of last year I sent my Orion II to Ten Tec for a simple 
> alignment.  With the exception of a very minor alignment issue (perfect on 
> 40m, 20Hz off on 10m), the rig functioned as it should when I sent it to the 
> repair facility.
> 
> I'm sure that by now we all know that the repair facility closed down in 
> December, and my rig was shipped back to me by Ten Tec.  While I thank Mike 
> for taking care of this, and rejecting offers he received to buy the lot, I 
> do have a complaint.  My rig has come back to me in non-functioning condition.
> 
> The rig won't power up.  When plugged in to power only (no other connections) 
> there is an awful buzzing noise when I flip the switch.  The rig immediately 
> draws around 6 amps and drops the voltage on an Astron RS-35M to about 5 
> volts.  Obviously I don't leave it in this condition, but the rig is now 
> useless to me until I can figure out how to fix it and where to start.
> 
> It might be important to note that I rebuilt the A9 board when I got 
> it--worked perfectly when I sent it in.
> 
> Has anyone else run into an issue like this?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>