| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Orion II Rev. 2.044A |
| From: | Dennis OConnor via TenTec <tentec@contesting.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 15 May 2020 23:59:55 +0000 (UTC) |
| List-post: | <mailto:tentec@contesting.com> |
Has a fresh master battery and hard reset. Works perfect except I cannot get it to transmit on Ant 2 no matter what I do. I have read the manual until my eyes water. Gone through every line item in the menus Is this a firmware upgrade issue or am I just dense :) _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Ten Tec 236 clone cable, Mike Cumbo |
|---|---|
| Next by Date: | [TenTec] Eagle: deaf receiver until a brief transmission is initiated, Carlos PECO BERROCAL |
| Previous by Thread: | [TenTec] Ten Tec 236 clone cable, Mike Cumbo |
| Next by Thread: | Re: [TenTec] Orion II Rev. 2.044A, Rodney Dewald via TenTec |
| Indexes: | [Date] [Thread] [Top] [All Lists] |