TenTec
[Top] [All Lists]

Re: [TenTec] N1 and N2 slots

To: tentec@contesting.com
Subject: Re: [TenTec] N1 and N2 slots
From: Stan Gammons <s_gammons@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 12 Aug 2017 23:24:53 -0500
List-post: <mailto:tentec@contesting.com>
Looks like I misread, again. The later Omni VI and Omni VI+ had 3 - 9 Mhz IF filter slots? Must have SMT components on that 9 Mhz IF board. I don't see how one could put 3 filters on that board otherwise. The Omni VI I have only has 2, so I guess there is no N1 and N2.


73

Stan
KM4HQE


On 08/12/2017 10:57 PM, Stan Gammons wrote:
On 08/12/2017 09:37 PM, Ken Brown wrote:

If you have a Omni VI+ or a later Omni VI that was upgraded it will have
two optional narrow 9 MHz IF filter slots, which are selected by the N1 and N2 buttons. You can use one or the other, or none, but not both. Again the
2.4 kHz "non-option" filter is always in use for both TX and RX..

Hi Ken,

It has the 9 Mhz IF board with 2 filter positions. One has a 2.4 Khz filter and the position maked optional has no filter. N1 and N2 buttons? There are no buttons on the front panel marked N1 and N2. So, I'm kind of lost...


73

Stan
KM4HQE


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>