Yep, Greg. Great suggestion. I tried that in the beginning.
73s,
Rick
Sent from my iPhone
> On Jan 11, 2017, at 1:09 PM, Greg S via TenTec <tentec@contesting.com> wrote:
>
> Only because it's easy to check-- AND overlook (Not that I have done such
> things......).... is the correct antenna output selected?
> 73- Greg, KC8HXO
>
>
> From: Rick via TenTec <tentec@contesting.com>
> To: TenTec@contesting.com
> Cc: wo8l@aol.com
> Sent: Tuesday, January 10, 2017 5:48 PM
> Subject: [TenTec] OMNII Problem
>
>
> Hi,
>
> I have an OMNI VII issue.
>
> When I boot up the rig, it initially shows a 1.1 to 1 swr but quickly goes to
> 9.1.1 to 1 and won't transmit or tune up with the auto tuner or a big manual
> tuner.
>
> I've used two AC power supplies and a battery. Two antennas and a dummy
> load. Same result. Sometimes the rig shows a high current message.
>
> Have done partial and full resets to no avail.
>
> Ideas?
>
> It always worked fine before this.
>
> Maybe the high current protecting rectifier is bad?
>
> 73s,
>
> Rick
> WO8L
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|