TenTec
[Top] [All Lists]

Re: [TenTec] rx 366

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] rx 366
From: Carl Moreschi <n4py2@earthlink.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 04 Jun 2012 15:38:55 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes, that is correct.  My N4PY Orion software has a setup to run the 366 
as VFO A for Panadpater use.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 6/4/2012 1:46 PM, John Molenda wrote:
> On 6/4/2012 5:47 AM, Barry N1EU wrote:
>> No on both counts.  I believe the 9Mhz out uses the existing "spare"
>> connector and a pluggable jumper between RX366 and that connector.
>>
>> 73,
>> Barry N1EU
>>
>> On Mon, Jun 4, 2012 at 1:44 AM, John Molenda<cdistflatfoot@gmail.com>   
>> wrote:
>>> Hello, I would like to know if the new Rx 366 board mod takes away
>>> general coverage receive from the radio.  Does the radio need to be sent
>>> back to TT for the 9 Megahertz out jack mod ?  thanks John Molenda
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> OK so if we were to hook up to a pan adapter it would only be reading
> what is on Rx 2or vfo 2  correct ?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>