Barry,
The Corsair I also had a digital display done with a dedicated display
chip which is about the same as a microcontroller. If you don't want any
digital at all you need an Omni A Series B - analog display only. Curt ask
about a "microprocessor for control." None of the radios used a microprocessor
for control - only to display the frequency.
Jerry W5JH
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com] On
Behalf Of Barry N1EU
Sent: Tuesday, September 06, 2011 1:47 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Last Ten-Tec to NOT use Microprocessor?
Actually, I think the Corsair II was the first model that did use a
microprocessor, so the Corsair would be the last model to not use a
microprocessor.
Barry N1EU
On Tue, Sep 6, 2011 at 2:32 PM, Hulett, Russell
<rhulett1@consolidated.net> wrote:
> The discussion about Corsair II replacement logic board prompts a question.
> What was the last model that didn't use a microprocessor for control? The
> Corsair or the Omni C or ?
>
> 73, Curt KB5JO
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|