Kris,
Many of the obsolete Ten Tec Manuals can be downloaded from Ten Tec
including the 535/536 Manual by going to http://radio.tentec.com/downloads/
then choose the Obsolete Manual tab. The 535/536 is the first one on the
list.
Stephen AD7TD
-----Original Message-----
From: Kris Merschrod
Steve,
(It is lamentable that the manuals for all Tentec rigs are not on a website
to make reference to.) There are two 8-pin (DIN-type) jacks on the rear of
the rigs. 1) is for linking to a tuner and gives out the band that the rig
is set to. 2) is both an audio input and output, and keying control for
amp-to-rig. The psk-type linking is done through this jack. There is recvr
muting on one pin, etc.
If anyone needs the exact tect I'll be happy to type out the pin
descriptions from page 2-10 of the 535/536 manual.
Kris (KA2OIG)
Merschrod
123 Warren Road
Ithaca, NY 14850
www.merschrod.net
----- Original Message -----
From: "Steve Berg" <wa9jml@tbc.net>
To: "N4PY2"
> Carl,
>
> What sort of rig control was present in the Delta II and Argonaut II
> radios. There is a jack on the back panel and as I remember Ten Tec
> made some sort of digital adapter for these radios.
>
> 73,
>
> Steve WA9JML
>
> N4PY2 wrote:
>> The Paragon was the first Tentec radio with computer control. The Omni V
>> was the first Omni series with computer control.
>>
>> Carl Moreschi N4PY
>> 121 Little Bell Drive
>> Hays, NC 28635
>> www.n4py.com
>>
>>
>> ----- Original Message -----
>> From: "Bob AD5VJ"
>>>>
>>> What model does tentec start with using computer control?
>>>
>>> Bob AD5VJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|