TenTec
[Top] [All Lists]

Re: [TenTec] Omni VII Query

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VII Query
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 10 Dec 2009 02:48:57 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
With my learner's permit in hand, I wonder how you
tested output - CW... SSB ... or some more exotic
measure?

Also what is the error tolerance (+/-) of the meter, I
have read some have as much as 10% variance +/-
and if so, it could be that you are getting 95 watts out
and reading only 85 ?

Also, when you tested, what was the load - antenna, or
dummy load, or can/do you test at a point earlier in
the system?   I am taking it that the "lab grade" 50 ohm
load is a high quality dummy load  (i.e., a known quantity).

I am not being critical...  just looking to learn and apply
a limited knowledge at this point.

Thanks.

=============  JHR  ==================


Val Erwin wrote:
> Omni VII-ites'
>  
> I have an Omni VII that is appx. 2 years old. Over time, I have noticed a 
> gradual decrease in RF output power. 
>  
> With 13.8 VDC measured at the radio power connector, the Omni VII digi-panel 
> states: "Power 100W".  Yet, when the RF output power is measured with a 
> lab-grade 50-ohm load and either a Bird 43 or a calibrated oscilloscope, the 
> measured RF power is actually on the order of 85 watts output, regardless of 
> band.
>  
> I suspect I have an aging component sitcheeashun'..........Is there an 
> internal control to crank the RF back up to spec??
>  
> TNX in advance for any feedback.........
>  
> Val / W5PUT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>