TenTec
[Top] [All Lists]

Re: [TenTec] Status of New Display Board for OMNI VII

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Status of New Display Board for OMNI VII
From: Mike Christiansen <starmike@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 17 Aug 2008 19:01:51 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Carl, that is a brand new webpage the Tentec just put up last week, so  
the information IMO is current.  This may not be the news your friend  
was hoping for

Mike, N4GW

On Aug 17, 2008, at 6:40 PM, Carl J. Denbow wrote:

> Thanks, Mike. If this is not an old, not-updated post, I was lied to  
> at
> Dayton.  I was shown a prototype board and was told it was ready for
> production.  In fact, I was told that the week after Dayton they would
> be having a production meeting and that the board would be ready for
> general sales within three months or so.  A friend of mine who  
> bought an
> ORION II about three years ago was told at that time that the board
> would be ready "in a few months."  He's ready to ditch his Ten-Ten
> equipment he is so mad about this issue.  When I gave him the
> information from Dayton, including my live sitting of the prototype
> board, he calmed down a little and said he'd give Ten-Tec a few more
> months.  In short, I hope what I was told at Dayton is more accurate
> than this link.  Perhaps, at this juncture Ten-Tec's recent "sins" are
> no more than not updating a web page! :-)
>
> Mike Christiansen wrote:
>> Check this link at the Tentec site.  it should answer your questions
>>
>> http://radio.tentec.com/status/
>>
>>
>> On Aug 17, 2008, at 4:19 PM, Carl J. Denbow wrote:
>>
>>
>>> Does anyone know the status the new display board that is coming out
>>> for
>>> the OMNI VII and ORION II?  I saw a prototype at Dayton and was
>>> assured
>>> that it was ready for production.  This board will allow, among  
>>> other
>>> things, for real time, continuous spectrum scope (like the ICOM 756
>>> pro
>>> series has).  I'm really looking forward to this new board, which is
>>> supposed to cost in the $300.00 range.
>>>
>>> Carl
>>> N8VZ
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>