John,
When you go to LCW or UCW, the receiver is offset by the frequency of the
"spot" frequency. Some times I have to check into the Badger Weather Net on
3985 on CW even though it is SSB. When I change from LSB to LCW and open
the filter, I have to tune down 700 Hz to 3984.3 to copy the SSB. I then
turn on the XIT and set it to -700 so they can copy my note. Otherwise I
will be on 3985 and not create a tone in their receiver. Try it sometime.
73,
John
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of John B. Egger
Sent: Friday, October 27, 2006 8:48 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] UCW and LCW
I'm a bit puzzled by these two O-2 modes. When UCW is selected, the
lower CW sideband is audible; that is, if zero-beat is 7020, to hear the
signal one tunes down to 7019 etc. When LCW is chosen, one must tune UP
from zero-beat to hear the signal.
Isn't this the opposite of what LCW and UCW should mean?
--
--John K3GHH
Registered Linux User #291592
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|