TenTec
[Top] [All Lists]

Re: [WriteLog] Re: interface Orion with Writelog

To: SteveBaron@StarLinX.com ("Steve Baron - KB3MM")
Subject: Re: [WriteLog] Re: interface Orion with Writelog
From: WB3LGC@aol.com
Date: Fri, 20 Aug 2004 14:20:46 -0400
List-post: <mailto:writelog@contesting.com>
that is why MicroHAM adds this information for the Orion:

If you plan to use the interface with N4PY software, the TenTec GUI, or 
firmware updates to the radio then order the USB <--> RS232 model with full 
handshaking lines (RTS, CTS, etc.).  Note that this does not provide the PTT or 
CW keying capabilities needed for some contest software.
 
If you plan to use contest software that provides a CW keying
output, but you do not need to use the TenTec GUI or do firmware updates, then 
order the DB9-T interface, which provides cables for PTT and CW keying output 
as well as footswitch PTT input.  Note that it cannot be used for the TenTec 
GUI or firmware updates, which require that RTS/CTS be wired to the DB-9 
connector.
 
---------------
Information (use of RTS/CTS)is also in the software programmers manual for the 
Orion.  See rfsquared.com
73, Steve

In a message dated 8/20/2004 1:59:37 PM Eastern Daylight Time, "Steve Baron - 
KB3MM" <SteveBaron@StarLinX.com> writes:
>
>Guess I didn't know that Orion requires thoe two signals. ?If it really uses 
>them the jumper could cause some data errors I guess ?
>

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [WriteLog] Re: interface Orion with Writelog, WB3LGC <=