TenTec
[Top] [All Lists]

RE: [TenTec] Orion 1.369 Features and general ruminations

To: <tentec@contesting.com>
Subject: RE: [TenTec] Orion 1.369 Features and general ruminations
From: "John L Merrill" <jmerrill1@adelphia.net>
Reply-to: tentec@contesting.com
Date: Sun, 22 Feb 2004 13:48:46 -0500
List-post: <mailto:tentec@contesting.com>
Grant:
They haven't cured our 80/40 meter anomally yet. I've talked to a couple of
others and they don't have the problem.....strange, as Ten Tec didn't.

John N1JM

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Grant Youngman
Sent: Sunday, February 22, 2004 1:32 PM
To: tentec@contesting.com; orion@contesting.com
Subject: [TenTec] Orion 1.369 Features and general ruminations


I noticed a few additional POD features in 1.369.  Sorry if this is
redundant ... I don't recall seeing anything about it, but I've been
basking with Hawaiian sea turtles for two weeks, and haven't paid
much attention to anything else :-)

F1-3 can now be set to "RIT/XIT Clear"

The POD encoder can also be set to XIT/RIT, BW, and PBT.  When
set to PBT, however, it appears to do HI/LO cut instead, depending
on whether HI or LOW cut is selected by the main control -- doesn't
appear to work right if the intent was actually PBT.  And the issue
that deals with the PBT numeric display when HI/LOW cut is used
hasn't been fixed yet.

I'd still like to see something like "." on the POD toggle the XM
tuning rate adjustment.

I know there are some other buggies and things that T-T has been
made aware of that haven't been fixed yet.  Hope these get taken
care of sooner than later.


-------------------------------
Grant Youngman /NQ5T
http://www.globeking.com
nq5t@comcast.net

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>