TenTec
[Top] [All Lists]

Re: [TenTec] Omni 6 Rig Control

To: <tentec@contesting.com>
Subject: Re: [TenTec] Omni 6 Rig Control
From: "George Tuncil" <w6aea@msn.com>
Reply-to: tentec@contesting.com
Date: Tue, 25 Nov 2003 17:30:27 -0800
List-post: <mailto:tentec@contesting.com>
Thanks, Carl.  I was looking at maybe getting the TRX Manager program for rig 
control while using my Writelog program at the same time.  From what you are 
saying, "full" rig control on the Omni 6 would not be possible, even with the 
TRX Manager.  It sounds like I can't do what I want with my Omni 6.  Thanks for 
your help, I appreciate it.  73.  George W6AEA
  ----- Original Message ----- 
  From: Carl Moreschi 
  To: tentec@contesting.com 
  Sent: Tuesday, November 25, 2003 1:06 PM
  Subject: Re: [TenTec] Omni 6 Rig Control


  The Omni VI has no provision for computer control of audio level, rf level,
  power level, etc.  The only parms that can be computer controlled in the
  Omni VI are frequency, mode, filter, vfo selection, and split on/off.  I
  hope I'm not forgetting one.

  73,

  Carl Moreschi N4PY
  Franklinton, NC
  ----- Original Message -----
  From: "George Tuncil" <w6aea@msn.com>
  To: <TenTec@contesting.com>
  Sent: Tuesday, November 25, 2003 6:10 PM
  Subject: [TenTec] Omni 6 Rig Control


  Thanks for all of the feedback regarding my rig control question.  I have
  connected my Omni to the COMM1 port via the 25 pin cable.  After doing the
  port selection criteria in my Writelog program, the only rig information
  that I have on my screen is frequency and mode.  Adjusting these parameters
  requires either manual action on the computer (new frequency/mode entry via
  a window) or adjustment at the rig on the tuning knob.  Any adjustments to
  any other parameter, such as power level, AF gain, etc. still must be done
  at the radio and are not visible on the screen.  It would sure be great to
  totally control the radio from the computer.  Any ideas of what I am doing
  wrong with either the Writelog program or my interface set-up?  Thanks in
  advance.  73.

  George W6AEA
  w6aea@msn.com
  _______________________________________________
  TenTec mailing list
  TenTec@contesting.com
  http://lists.contesting.com/mailman/listinfo/tentec

  _______________________________________________
  TenTec mailing list
  TenTec@contesting.com
  http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>