TenTec
[Top] [All Lists]

Re: VS: [TenTec] Orion and MIKEs

To: <tentec@contesting.com>
Subject: Re: VS: [TenTec] Orion and MIKEs
From: "Josh Kelly" <jkelly@HiWAAY.net>
Reply-to: Josh Kelly <jkelly@HiWAAY.net>, tentec@contesting.com
Date: Fri, 7 Nov 2003 07:14:03 -0600
List-post: <mailto:tentec@contesting.com>
Yep, this caused a real problem for me and W2IHY.  I wanted to try my W2IHY
8 band Eq. but the

regular TenTec 4 pin adaptor will not key the Orion.  W2IHY is making me a
special adaptor for

this.  Don't pay any atention to the pin in the book.  DXUPON all es 73
Josh,  N4VB  in Alabama

----- Original Message ----- 
From: "John T. Fleming" <W3GQJ@comcast.net>
To: <tentec@contesting.com>
Sent: Friday, November 07, 2003 6:50 AM
Subject: RE: VS: [TenTec] Orion and MIKEs


> Yuri,
>
> I agree that something does not make sense.  On page 9 figure 2-3, they
show
> pin 4 as 9 volts plus.  On page 10, figure 2-4, they show pin 4 tied to
the
> case of the microphone and being part of the PTT connection.  Figure 2-5
> seems to match 2-3 and shows using the barrel for the shield and PTT
return.
> Hmmmmmm.
>
> I am using the September PDF manual from the web site.  I tried looking at
> the schematic PDF files, but could not find microphone file.  I gave up
> since there are 43 of PDF files.
>
> 73,
> John, W3GQJ
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of K3BU@aol.com
> Sent: Friday, November 07, 2003 5:54 AM
> To: tentec@contesting.com
> Subject: Re: VS: [TenTec] Orion and MIKEs
>
> In a message dated 11/6/03 11:45:32 PM Eastern Standard Time,
> elstar@elstar.fi writes:
> >>Do you really think , that shield must be in rig ground and mig body
> ground
> even you had mic in metal or semiconductor box ?
> Did I understand wrong?
> I am still quite sure, that only rig end grounding is best way.<<
>
>
>
> What I was questioning in discrepancy between the two drawings in the
manual
>
> and different way of wiring grounds. If it was error in drawings or some
> good
> reason for it, which I could not see.
>
> I use shielded cables for my mike and PTT foot switch, both shields tied
to
> pin 2.
>
> Yuri
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>