TenTec
[Top] [All Lists]

[TenTec] Pegsus and 962 PS

To: <tentec@contesting.com>
Subject: [TenTec] Pegsus and 962 PS
From: wa3fiy@radioadv.com (WA3FIY)
Date: Fri, 4 Jan 2002 10:38:00 -0500
Don't despair Jim,

I ran into the same "problem".   So for a quick fix [which I am still 
using after six months BTW ]  I got a short piece of #12 solid 
copper house wire which just happens to fit perfectly into the power 
receptacle of the 962 PS.  

In each of the following cases, strip about 3/8 inch of insulation 
from each end of the wires and file off the ends of the wire smooth 
for easy insertion into the power jack of the PS.   Cut one short piece 
and bend it into a "U" shape and push it into the two middle 
connectors of the 962 PS.  That takes care of the AC power 
switching.  Cut another one, preferably black, an inch or so long and 
solder the black [neg] wire of the Jupiter power cable to one end.  
Insulate well.  Cut another wire the same length as the previous, 
preferably red or white, and solder it to the red wire of the Jup 
power cable.  Now....connect negative to negative and positive to 
positive and DOUBLE CHECK polarity by measuring the voltage at the 
Jupiter end of the power cable assy.  

I too ordered an adapter from Ten Tec but have not yet replaced the 
"adapter" just described.   This will at least get you going and 
enjoying your Jupiter. 

Good luck Jim.

-73-

-Lee-



On 3 Jan 2002, at 15:41, Jim Reid wrote:

> Exciting afternoon here.
> 
> The Fed Ex man delivered my new Pegasus 550 transceiver.
> 
> However,  I cannot now use it?!  When I ordered it,  I told
> Scott,  on the phone,  that I was going to use my 962
> PS with it.  No problem.  Well,  now the Peg is here,  and
> guess what?  The input power connector on the Pegasus
> is two pin,  and the 962 has a 4 pin plug!!  So,  Ten Tec
> sells a nice 4 to 2 adapter for only $5;  not a big deal.
> 


<Prev in Thread] Current Thread [Next in Thread>