TenTec
[Top] [All Lists]

[TenTec] omni c

To: <tentec@contesting.com>
Subject: [TenTec] omni c
From: crobson@erie.net (Chris Robson)
Date: Sat, 28 Mar 1998 11:30:18 -0500
At 08:55 AM 3/28/98 EST, you wrote:
>RECENTLY GOT A OMNI C FROM THE FACTORY WHICH I LIKE VERY MUCH HOWEVER
,ABOUT 2
>WEEKS AGO THE SENSITIVTY DROPPED BY SEVERAL S UNITS AND IT HAD INTERMITTANT
>BURSTS OF NOISE!  I ALSO NOTICED THAT THE R F ATTENUATOR WAS NOT WORKING . A
>CALL TO THE TECH. AT TENTEC ADVISED THAT PROBABLY THE  PIN DIODES WERE BAD ON
>THE R F ATTEN. BOARD !  HE WAS CORRECT . I REPLACED THEM (SUPPLIED BY TEN
TEC)
>AND ALL IS BACK TO NORMAL . ALSO LOW SENS. COULD BE BAD DIODES ON THE SWR-T/R
>BOARD BUT MINE WERE OK  HOPE THIS MITE BE HELPFUL TO SOME  DE  JERRY K9UT


This was also a common problem with my Corsair, until Ten Tec made a mod to
the SWR board and added some MOVs, never had the problem again.  When I had
my Omni-C, I always kept some pin diodes around, their only about $1 at
Radio Shack, very common diode. Good luck with it.
73, Chris KB3A



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>