TenTec
[Top] [All Lists]

A couple more questions...

To: <tentec@contesting.com>
Subject: A couple more questions...
From: OGBORRW@texaco.com (Ogborn, Roy W)
Date: Wed, 15 Jan 1997 14:51:04 -0600
My previous list of questions concerning my newly acquired OMNI D
station was not long enough, so here are a few more...

1) My OMNI D came with a 20amp Astron power supply.  The power supply
has no provision for external chassis ground (that's evident anyway),
but has a three pronged AC cord, which does obviously get grounded.
Should I run a ground strap from the 12- terminal to my shack ground, or
should I put a strap on the large bolt on the bottom of the supply
(presumably holds down the xformer), or is the -12 line that goes to the
OMNI be enough?  (In other words, do the AC electric ground and the 12v
supply lines have me covered . . . if not, why is there no ground
wingnut type connection on the Astron power supply?)

2) The 20amp Astron power supply is rated at 16 amp continuous, 50% duty
cycle, 20amp CUI(?).  The OMNI D manual states it draws a max of 18.5
amps.  My Uncle had apparently been using this combination for some
time.  Are there any concerns I should have?  I.e., is the power supply
big enough?  What if I were to start using a data communication mode
(non-Morse)?

3) The OMNI calls for a high impedance mic to be connected.  What
happens if I connect a low impedance (600 ohm) mic to the jack?

Thanks once again!

Roy Ogborn
KI0ER - Colorado
ki0er@amsat.org

--
FAQ on WWW:               http://www.contesting.com/TenTecFAQ.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 w9tw@contesting.com
Sponsored by:             Akorn Access, Inc & N4VJ / K4AAA

<Prev in Thread] Current Thread [Next in Thread>