CT-User
[Top] [All Lists]

[ct-user] ROTOR CONTROL

To: <ct-user@contesting.com>
Subject: [ct-user] ROTOR CONTROL
From: nd5s@ix.netcom.com (Ron St.Laurent)
Date: Tue, 20 Nov 2001 21:23:28 -0500
Don,

Thanks.  I found it in the release notes.  It is CTRL F10 and it is working
fine.

Ron

----- Original Message -----
From: "Don Melcher" <don@hfradio.com>
To: "Ron St.Laurent" <nd5s@ix.netcom.com>
Sent: Tuesday, November 20, 2001 20:51
Subject: RE: [ct-user] ROTOR CONTROL


> It would be in the release notes - quite a few versions ago, not the
manual,
> and then there is a selection in the setup - but can't remember the
> command - I switched to  WriteLog a long time ago.
>
> -----Original Message-----
> From: ct-user-admin@contesting.com
> [mailto:ct-user-admin@contesting.com]On Behalf Of Ron St.Laurent
> Sent: Tuesday, November 20, 2001 5:31 PM
> To: ct-user
> Subject: [ct-user] ROTOR CONTROL
>
>
> This will be the first CQWW in which I have DCU capability with my rotor.
>
> I searched the archives and the manual for rotor control information.  I
> give up!  Can someone point me in the right direction?  I'm sure it's
there,
> I just can't seem to find it.
>
> Thanks,
> Ron ND5S
>
> Visit my Webpage at:
> http://www.qsl.net/nd5s
>
> _______________________________________________
> ct-user mailing list
> ct-user@contesting.com
> ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
>


<Prev in Thread] Current Thread [Next in Thread>